SPLACH Phoenix Manual

    Programming Codes

    Codes Setting Content
    P01 Voltage Level 48V / 52V / 60V
    P02 Mileage Unit 0: KM/H / 1: MPH
    P03 Dormancy Time 0: No sleep mode / Other values represent sleep time in minutes (1-60)
    Default: 5 minutes
    P04 Wheel Diameter 8-20 inches
    Default: 10 inches
    P05 Zero Start 0: Zero start / 1: Non-zero start
    P06 Magnet Count for Speed Measurement Range: 1-99
    Default: 30
    P07 Cruise Control 0: Off / 1: On
    P08 Electronic Braking Level Range: 1 (weakest) to 5 (strongest)
    Default: 3
    P09 Front Motor Start Strength Range: 0-2
    Default: 1
    P10 Rear Motor Start Strength Range: 0-2
    Default: 1
    P11 ODO Zero Setting Hold “+” for 3 seconds until “00” changes to “01” (Restart to reset ODO)
    P12 Restore Default System Settings Hold “-” for 3 seconds until “00” changes to “01” (Restart to restore defaults)

    Error Codes

    Fault Code Fault Condition
    E-01 Motor phase loss
    E-02 Brake lever fault
    E-04 Controller communication fault
    E-08 Undervoltage protection fault
    E-10 Controller fault
    E-20 Throttle fault
    E-40 Hall sensor fault
    E-80 Instrument panel communication fault